3-2
Supplement for the Programmer’s Guide (Firmware Revision 7.66)
In This Chapter
In This Chapter
This chapter contains the supplemental information changes to the programmer’s guide
that coincides with the release of firmware revision 7.66. These changes pertain to:
The Programmer’s Guide for 8719ET/ES, 8720ET/ES, 8722ET/ES, and 8753ET/ES
Network Analyzers (part number 08753-90475)
The following list describes the changes to programmer’s guides printed prior to July 2000.
Each of the changes are described in detail in the remainder of this chapter. The page
references in this list refer to page numbers in this supplement.
• Alphabetical Command Reference Chapter
— Add 20 programming commands. See the “Alphabetical Command Reference” on
page 3-3.
• Appendix A: Preset Conditions
— Replace the Limit Line Conditions table in the “Preset State” section using Table 3-1
on page 3-15.
• Appendix B: Command Listings
— Add 22 new programming commands to the “Alphabetical List of Commands” using
the “Alphabetical List of New Commands” on page 3-17.
— Add one new programming command to the “OPC-Compatible List of Commands”
using the “OPC-Compatible List of New Commands” on page 3-17.
To Next Page
Loading...
Need help?
General
