20
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step2.fm
Step 2: Configure the Base Station Emulator (BSE)
Configuring the Broadcast Channel Parameters
The broadcast channel parameters are configured using the CALL processing subsystem commands shown in
the following table.
Table 1. Broadcast Channel Settable Parameters
Parameter Command Syntax Footnote
Broadcast Band
CALL[:CELL[1]]
:BAND <PGSM|EGSM|DCS|PCS>
1Cell Power CALL[:CELL[1]]:POWer[:AMPlitude]<numeric value>[<suffix>]
Cell Power State CALL[:CELL[1]]:POWer:STATe <ON|1|OFF|0>
Cell Power and State CALL[:CELL[1]]:POWer[:SAMPlitude]<numeric value>[<suffix>] 2
Cell BCH Number CALL[:CELL[1]]:BCHannel[:ARFCn][:SELected]<numeric value>
OR
CALL[:CELL[1]]
:BCHannel[:ARFCn]:<PGSM|EGSM|DCS|PCS>
<numeric value>
3
Mobile Country Code CALL[:CELL[1]]:MCCode <numeric value> 4
PCS Mobile Country Code CALL[:CELL[1]]:PMNCode:VALue <numeric value> 4
Use PCS MNC CALL[:CELL[1]]:PMNCode:STATe <ON|1|OFF|0> 4
PCS Mobile Country Code
and Use PCS NMC State
CALL[:CELL[1]]:PMNCode[:SVALue] <numeric value> 4, 5
Mobile Network Code CALL[:CELL[1]]:MNCode <numeric value> 4
Location Area Code CALL[:CELL[1]]:LACode <numeric value> 4
Network Color Code CALL[:CELL[1]]:NCCode <numeric value> 4
Base Station Color Code CALL[:CELL[1]]:BCCode <numeric value> 4
Paging IMSI CALL:PAGing:IMSI <string>
Repeat Paging State CALL:PAGing:REPeat[:STATe] <ON|1|OFF|0>
Paging Mode CALL:PAGing:MODE <NORMal | REORg> 7
Paging Multiframes CALL:PAGing:MFRames <numeric value>
Auto IMEI Request CALL:IMEI:AUTO <ON|1|OFF|0>
BA Table Entries CALL[:CELL[1]]:BA:TABle[:SELected][<numeric value>{,<numeric
value>}]
OR
CALL[:CELL[1]]
:BA:TABle:<PGSM|EGSM|D
CS|PCS> [<numeric
value>{,<numeric value>}]
6
XXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
To Next Page
Loading...
Need help?
General
