Agilent Technologies 8960 Series Programming Guide

47
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step6a.fm
Step 6a: Start Set Of Concurrent Measurements
Step 6a: Start Set Of Concurrent Measurements
Starting Measurements
The INITiate command is used to start measurements. Each individual measurement in a test application can
be started using the INITiate command. For starting measurements, the syntax of the INITiate command is
as follows:
Example 1. Command Syntax:
INITiate:<meas-mnemonic>[:ON]
The following table shows the measurements available in the Agilent Technologies E1960A GSM mobile test
application and their associated <meas-mnemonic> used in the INITiate command syntax.
Table 1. Measurement Mnemonics Used In The INITiate Subsystem
Measurement <meas-mnemonic>
Transmit Power TXPower
Power vs Time PVTime
Phase & Frequency Error PFERror
Output RF Spectrum ORFSpectrum
Bit Error BERRor
Fast Bit Error FBERror
Decoded Audio DAUDio
Analog Audio AAUDio
I/Q Tuning IQTuning
Dynamic Power DPOWer

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English