48
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step6a.fm
Step 6a: Start Set Of Concurrent Measurements
Example 2. Programming Example:
OUTPUT Test_set;"INIT:TXP"
would start the transmitter power measurement.
Using Compound Commands to Start Multiple Measurements
More than one measurement can be started using a single INITiate command. For example:
OUTPUT Test_set;"INIT:TXP;PFER"
would start the transmit power measurement and the phase and frequency error measurement. These
measurements would then run concurrently.
To Next Page
Loading...
