Agilent Technologies 8960 Series - Making Measurements on a Mobile

22
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step2.fm
Step 2: Configure the Base Station Emulator (BSE)
Configuring the Traffic Channel Parameters
The traffic channel parameters are configured using the CALL processing subsystem commands shown in the
following table.
Table Footnotes
1 The TCH band setting becomes the selected band (see Note 2).
2 Sets the TCH channel for the TCH band selected with the TCH Band command (see Note 1).
Example 2. Programming Example:
The following program example illustrates proper use of the BSE TCH configuration commands. Not all
parameters are accessed.
OUTPUT Test_set;”CALL:TCH 45”
OUTPUT Test_set;”CALL:TCH:TSL 4”
Table 2. Traffic Channel Settable Parameters
Parameter Command Syntax Footnote
TCH Band CALL:TCHannel:BAND <PGSM|EGSM|DCS|PCS> 1
Channel
Number
CALL:TCHannel[:ARFCn][:SELected] <numeric value>
OR
CALL:TCHannel[:ARFCn]:<PGSM|EGSM|DCS|PCS> <numeric value>
2
Loopback Mode CALL:TCHannel:LOOPback <OFF|A|B|C>
Timeslot CALL:TCHannel:TSLot <numeric value>
Downlink
Speech Source
CALL:TCHannel:DOWNlink:SPEech
<NONE|ECHO|PRBS15|SIN300|SIN1000|SIN3000>
XXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX