24
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step3.fm
Step 3: Configure the Measurement Execution Parameters
Step 3: Configure the Measurement Execution Parameters
Background
Measurement execution parameters control the conditions under which a measurement operates. The general
set of measurement execution parameters and their generic categories are as follows:
• Measurement Averaging (used by most measurements)
Multi-Measurement Count State
Multi-Measurement Count State
• Measurement Triggering (used by most measurements)
Trigger Arm
Trigger Source
Trigger Delay
Trigger Qualifier
• Measurement Synchronization (used by some measurements)
Burst Synchronization
• Measurement Timeouts (used by all measurements)
Measurement Timeout
Measurement Timeout State
• Measurement Specific (execution parameters specific to an individual measurement)
NOTE Not all measurements use all the execution parameters shown above. Additionally, some
measurements have parameters that are specific to the measurement such as offset frequency
lists or filter settings. Each measurement has its own set of parameters which are unique to it
and have no affect on the execution of other measurements. Refer to the GPIB syntax listing for a
detailed list of execution parameters for individual measurements.
To Next Page
Loading...
