Agilent Technologies AA Series - Installing the Spectraa CFR Software

Installation
50 Agilent 240/280 Series AA User’s Guide
11 When requested, remove the installation CD and replace it in the
CD drive with the SpectrAA Help and Videos CD ROM. Click OK
to install the Help.
12 From the ‘Install Videos’ window, you can select to copy the Help
videos to your hard disk (recommended). This will enable you to
view the videos at any time without inserting the Help and
Videos CD-ROM into the CD drive. Select the destination folder
for the videos (if applicable) and click Yes or No as required.
13 Once you have finished installing the base software, click Finish
to complete the SpectrAA Base installation. Follow the
instructions in the next section to install the SpectrAA CFR
software.
Installing the SpectrAA CFR Software
NOTE
Windows XP (SP3), with NTFS file system is required for the SpectrAA CFR
version. Currently, SpectrAA CFR is not compatible with Windows 7.
NOTE
Installation of the SpectrAA Base version 5.1 (27) must be completed prior to
installing the SpectrAA CFR software. Refer to Page 47 for details.
NOTE
The selections entered during installation of the Base software (e.g. User
Information, Directory Location) will be used for the CFR installation.
To install the SpectrAA CFR software:
1 Close down all Microsoft Windows applications.
2 Insert the SpectrAA CFR CD-ROM into your CD-ROM drive. The
installation program should start automatically. If the program
does not auto start, do the following:
a From the Windows Start menu, select Run. The Run dialog
displays.
b In the Run dialog, type X:\SETUP.EXE (where X represents
the letter of your CD-ROM drive) and select OK to start the
installation.