Getting Started
Agilent 240/280 Series AA User’s Guide 71
5. Getting Started
Instrument Setup 71
Connections 72
Power 72
Moving Your Instrument 73
Starting the System 73
Pre-analysis Checklist 74
This chapter describes how to set up the Agilent AA system for
analysis and get you started using the instrument.
You should have already:
Prepared your PC and installed the SpectrAA software as
described in Chapter 3.
Become familiar with the SpectrAA user interface as described in
Chapter 4.
Instrument Setup
Use the following checklist to ensure that you set up your system
correctly. You must:
Connect the components of the system to one another (see
‘Connections’ on Page 72).
Connect the equipment to the power supply, and check the
setting of the two voltage taps where fitted (see ‘Power’ on Page
72).
Install the hardware components as per your analytical
requirements. Refer to the Help for details.
To Next Page
Loading...
