Installation
42 Agilent 240/280 Series AA User’s Guide
Installing the SpectrAA Base Software
NOTE
This procedure is for SpectrAA version 5.2 or greater and Microsoft Windows 7
Professional 64-bit SP1 operating systems only.
1 Close down all Microsoft Windows applications.
2 Insert the SpectrAA Base CD-ROM into your CD-ROM drive. The
installation program should start automatically. If the program
does not auto start, do the following:
a From the Windows Start menu, select All Programs >
Accessories > Run. The Run dialog displays.
b In the Run dialog, type X:\SpectrAABase.exe (where X
represents the letter of your CD-ROM drive) and select OK to
start the installation.
c Click Yes on the User Account Control window to run the
program.
3 Select the language from the drop-down menu to use during the
installation of the SpectrAA software. Click OK.
4 Select Next to start the installation.
5 Review the License Agreement and then select I accept the
agreement and then click Next or ‘Cancel’ if you do not accept
the agreement. Clicking ‘Cancel’ will stop the software
installation.
6 Follow the prompts, selecting Yes, Next or OK on each page.
7 The SpectrAA User Information window will be displayed.
Check that the selections are correct, or reenter them, and then
click Next.
8 Follow the prompts, selecting Yes, Next or OK on each page.
9 Click Install.
10 From the ‘SpectrAA Instrument Configuration’ window, select
your instrument type from the drop down list on the
‘Instrument #1’ page. Then do the following:
If you are running a one instrument system:
Continue with Step 11.
To Next Page
Loading...
