Chapter 4
Front-Panel Key and SCPI Command Reference
Front-Panel Keys
150
Front-Panel Key and SCPI Command
Reference
4.2.6.3 Restart
Press this key to repeat the current measurement from the beginning, while retaining the current measurement
settings. This is equivalent to the
Restart front panel key.
4.2.7 Mode
Accesses any installed personality modes. The minimum set of available modes will be Spectrum Analysis and
Measuring Receiver. This menu will have additional entries if other personalities have been installed, for
example GSM/EDGE Option 202 or cdmaOne Option BAC.
4.2.7.1 Spectrum Analysis
For information related to the operation of the Spectrum Analysis mode refer to the PSA User’s/Programmer’s
Guide.
4.2.7.2 Measuring Receiver
The Measuring Receiver mode provides you the ability to set up your own measurement environment to measure
RF frequency, RF power and tuned RF level, and analyze AM/FM/PM and audio signals.
4.2.7.2.1 Instrument Selection by Name (Remote command only)
Selects the measurement mode. The actual available choices depend upon which modes (measurement
applications) are installed in the instrument. A list of the valid choices is returned with the INST:CAT? query.
Once an instrument mode is selected, only the commands that are valid for that mode can be executed.
Key Path: Meas Control
Remote Command: No equivalent command.
Remote Command Notes: This could be done by sending an :ABORt command followed by
an:INITiate[:IMMediate] command.
Remote Command :INSTrument[:SELect]
SA|PNOISE|BASIC|CDMA|CDMA2K|EDGEGSM
|NADC|PDC|WCDMA|CDMA1XEV|NFIGURE|WLAN|MRECEIVE
:INSTrument[:SELect]?
Example :INST MRECEIVE
:INST?
Key Path
Mode
To Next Page
Loading...
Need help?
General
