Chapter 4
Front-Panel Key and SCPI Command Reference
Front-Panel Keys
151
Front-Panel Key and SCPI Command
Reference
NOTE If you are using the status bits and the analyzer mode is changed, the status bits should be read,
and any errors resolved, prior to switching modes. Error conditions that exist prior to switching
modes cannot be detected using the condition registers after the mode change. This is true unless
they recur after the mode change, although transitions of these conditions can be detected using
the event registers.
Changing modes resets all SCPI status registers and mask registers to their power-on defaults.
Hence, any event or condition register masks must be re-established after a mode change. Also
note that the power up status bit is set by any mode change, since that is the default state after
power up.
4.2.7.2.2 Instrument Selection by Number (Remote command only)
Selects the measurement mode by its instrument number. The actual available choices depends upon which
applications are installed in the instrument.
1 = SA (PSA/ESA)
3 = GSM (GSM on E4406A, and GSM or GSM w/EDGE on ESA)
4 = CDMA (cdmaOne) (E4406/ESA/PSA)
5 = NADC (E4406/PSA)
6 = PDC (E4406/PSA)
8 = BASIC (E4406/PSA)
9 = WCDMA (3GPP W-CDMA with HSDPA/HSUPA) (E4406/PSA)
10 = CDMA2K (cdma2000 with 1xEV-DV) (E4406/PSA)
13 = EDGEGSM (E4406/PSA)
14 = PNOISE (phase noise) (ESA/PSA)
15 = CMDA1XEV (1xEV-D0) (E4406/PSA)
211 = TDSCDMA (PSA)
241 = DMODULATION (PSA)
217 = WLAN (PSA)
219 = NOISEFIGURE (ESA/PSA)
233 = MRECEIVE (PSA)
Remote Command :INSTrument:NSELect 233
:INSTrument:NSELect?
Example :INST:NSEL 233
:INST:NSEL?
Key Path
Mode
To Next Page
Loading...
Need help?
General
