204 Chapter 4
Instrument Functions: P - Z
Peak Search
Instrument Functions: P - Z
4.1.1 Next Peak
Places the marker on the next highest peak with an amplitude less than the current peak.
The peak must meet the defined peak excursion and threshold values. Peaks that are less
than 1% of the current span away from 0 Hz are ignored. If no valid peak is found, an error
(
No Peak Found) is displayed. Press ESC to clear this message before attempting another
search. (Also see the
Peak Excursn and Pk Threshold key descriptions.)
Key Path:
Peak Search
State Saved: Not part of saved state.
Remote Command:
:CALCulate:MARKer[1]|2|3|4:MAXimum:NEXT
Example: CALC:MARK2:MAX:NEXT selects marker 2 and moves it to the next highest
peak.
4.1.2 Next Pk Right
Moves the marker to the next peak to the right of the current marker. The peak must meet
the defined peak excursion and threshold limits. Peaks that are less than 1% of the current
span away from 0 Hz are ignored. If no valid peak is found, an error “
No Peak Found” is
displayed. Press
ESC to clear this message before attempting another search. (Also see the
Peak Excursn and Pk Threshold key descriptions.)
Key Path:
Peak Search
State Saved: Not part of saved state.
Remote Command:
:CALCulate:MARKer[1]|2|3|4:MAXimum:RIGHt
Example: CALC:MARK2:MAX:RIGH selects marker 2 and moves it to the next peak to
the right.
To Next Page
Loading...
Need help?
General
