Chapter 4 249
Instrument Functions: P - Z
System
Instrument Functions: P - Z
Remote Command:
:DISPlay:ANNotation:CLOCk:DATE:FORMat MDY|DMY
:DISPlay:ANNotation:CLOCk:DATE:FORMat?
Example: DISP:ANN:CLOC:DATE:FORM DMY
4.9.3.3 Set Time
Enables you to set the time of the real-time clock. Enter the time in 24 hour HHMMSS
format.
Key Path: System, Time/Date
Dependencies/
Couplings:
None
State Saved: Survives
Preset and power cycle, but not saved in Instrument State.
SCPI Status Bits/
OPC Dependencies: None
Factory
Default: Not affected by “
Restore Sys Defaults.”
Terminators: Unitless
Default Terminator: None
Range: Hour (HH): 00 to 23.
Minute (MM): 00 to 59.
Second (SS): 00 to 59.
Remote Command:
:SYSTem:TIME <hour>,<minute>,<second>
:SYSTem:TIME?
Example: SYST:TIME 12,42,00 Sets the clock to 12:42:00 PM.
4.9.3.4 Adjust Time Setting (Remote Command Only)
Adjust the instruments internal time by the value entered.
Key Path: System, Time/Date
SCPI Status Bits/
OPC Dependencies:
None
Terminators: No units are allowed with the command.
DefaultTerminator seconds
To Next Page
Loading...
