60 Chapter 2
Instrument Functions: A - L
Auto Couple
Instrument Functions: A - L
2.2.2.3 Manual: Swept
Manually selects swept analysis, so it cannot change automatically to FFT.
While Zero Span is selected, this key is grayed out. The status of the FFT & Swept selection
is saved when entering zero span and is restored when leaving zero span.
Key Path:
Auto Couple, FFT & Sweep
Saved State: Saved in instrument state
Remote Command:
Use [:SENSe]:SWEep:TYPE AUTO|FFT|SWEep
See “FFT & Sweep” on page 58.
Example: SWE:TYPE SWE
2.2.2.4 Manual: FFT
Manually selects FFT analysis, so it cannot change automatically to swept.
While
Zero Span is selected, this key is grayed out. The status of the FFT & Swept selection
is saved when entering zero span and is restored when leaving zero span.
To Next Page
Loading...
