Agilent Technologies G1330B User Manual

32
Installing the G1330B Thermostat
Installing the G1330B Thermostat
6 If required, connect additional interface and control cables to the
thermostatted autosampler (see Figure 7 and Figure 13). Refer to the
documentation of the Agilent 1100 Series control module or ChemStation for
LC for more information.
NOTE In an Agilent 1100 Series system, the individual modules are connected by a
CAN cable. The Agilent 1100 control module can be connected to the CAN bus
at any of the modules in the system. The Agilent Chemstation can be
connected to the system by one GPIB cable at any of the modules, however, it
is recommended to connect the GPIB cable to the detector. For more
information about connecting the control module or ChemStation refer to the
respective user manual. For connecting the Agilent 1100 Series equipment to
non-Agilent 1100 Series equipment, see Autosampler manual).
7 Connect additional cables as required (see Figure 13).
Figure 12 Power Connectors and Safety Levers at Rear of thermostatted Autosampler.
Safety lever
Power connector
Autosampler - Thermostat
Cable

Agilent Technologies G1330B Specifications

General

Brand	Agilent Technologies
Model	G1330B
Category	Thermostat
Language	English