39
Installing the G1330B Thermostat
Installing the G1330B Thermostat
can be obtained from the Internet (http://www.chem.agilent.com/cag/
literature/apglit.html) or your local Agilent Technologies sales office.
1 If you decide to update your A.04.01 Agilent ChemStation to A.05.01, use the
provided A.05.01 CD-ROM and follow the steps described in the Installing
your ChemStation manual, provided as portable document format (PDF) file
on the A.05.01 CD-ROM in the directory MANUALS\INSTALL\LC. If you do not
already have the Adobe Acrobat reader installed, use the file
MANUALS\READER\AR32e30.EXE to install the reader.
2 After you have updated your system, insert the 3.5” floppy labeled ‘Driver
update Disk (A.05.02 Beta)’ and open a DOS prompt by selecting Start->RUN
and typing
command. At the DOS prompt type A: and press Enter and then
HPUPDATE and press Enter only if your Agilent ChemStation is installed in the
directory C:\HPCHEM. If your Agilent ChemStation is installed in a different
directory, e.g. D:\HPCHEM, you need to type
HPUPDATE D:\HPCHEM and
press Enter.
1 If you decide to update to A.04.02, insert the A.04.02 CD-ROM and select
SETUP on the CD-ROM using File Manager or Explorer. Select Yes to continue
with the update.
2 After you have updated your system, insert the 3.5 inch floppy labeled Driver
update Disk (A.04.03) and open a DOS prompt by selecting Start->RUN and
typing
command. At the DOS prompt type A: and press Enter and then
HPUPDATE and press Enter only if your Agilent ChemStation is installed in the
directory C:\HPCHEM. If your Agilent ChemStation is installed in a different
directory, e.g. D:\HPCHEM, you need to type
HPUPDATE D:\HPCHEM and
press Enter.
Starting from revision A.05.01 of the Agilent ChemStation
If you already have the Agilent ChemStation A.05.01 installed, you only need
to install the update to A.05.02 Beta. This update comprises only the driver
for the thermostatted autosampler, no other changes are made.
1 Insert the 3.5” floppy labeled Driver update Disk (A.05.02 Beta) and open a
DOS prompt by selecting Start->RUN and typing
command. At the DOS
prompt type
A: and press Enter and then HPUPDATE and press Enter only if
your Agilent ChemStation is installed in the directory C:\HPCHEM. If your
Agilent ChemStation is installed in a different directory, e.g. D:\HPCHEM, you
need to type
HPUPDATE D:\HPCHEM and press Enter.
To Next Page
Loading...
Need help?
General
