Agilent Technologies N6705

Appendix B SCPI Commands
188 Model N6705 User’s Guide
SCPI Command Description
SENSe:HISTogram (continued)
:FUNCtion
:CURRent <Bool>, (@chanlist)
Enables/disables current histogram (only on N6781A, N6782A)
:SWEep
:OFFSet
:POINts <NRf+>, (@chanlist)
Defines the trigger offset in the measurement sweep
:POINts <NRf+>, (@chanlist)
Defines the number of data points in the measurement
:TINTerval <NRf+>, (@chanlist)
Sets the measurement sample interval
:RESolution RES20 | RES40, (@chanlist)
Sets the measurement resolution
:VOLTage
[:DC]:RANGe
[:UPPer] <NRf+>, (@chanlist)
Selects the voltage measurement range
:AUTO <Bool>, (@chanlist)
Enables/disables measurement autoranging (N6781A, N6782A)
:WINDow
[:TYPE] HANNing | RECTangular, (@chanlist)
Selects the window type
[SOURce:]ARB
:COUNt <NRf+> | INFinity, (@chanlist)
Sets the Arb repeat count
:CURRent | :VOLTage
Specifies current or voltage Arbs
:CDWell
[:LEVel] < NRf+> {,<NRf>}, (@chanlist)
Sets the list of the constant dwell Arb
:DWELl < NRf+>, (@chanlist)
Sets the dwell time for the constant dwell Arb
:POINts? (@<chanlist>)
Returns the number of constant-dwell Arb points
:CONVert (@chanlist)
Converts the selected Arb to a user-defined list
:EXPonential
:END
[:LEVel] < NRf+>, (@chanlist)
Sets the end level of the exponential Arb
:STARt
[:LEVel] < NRf+>, (@chanlist)
Sets the initial level of the exponential Arb
:TIMe < NRf+>, (@chanlist)
Sets the length of the start time or delay
:TCONstant < NRf+>, (@chanlist)
Sets the time constant of the exponential Arb
:TIMe < NRf+>, (@chanlist)
Sets the time of the exponential Arb
:PULSe
:END
:TIMe < NRf+>, (@chanlist)
Sets the length of the end time
:STARt
[:LEVel] < NRf+>, (@chanlist)
Sets the initial level of the pulse
:TIMe < NRf+>, (@chanlist)
Sets the length of the start time or delay
:TOP
[:LEVel] < NRf+>, (@chanlist)
Sets the top level of the pulse
:TIMe < NRf+>, (@chanlist)
Sets the length of the pulse
:RAMP
:END
[:LEVel] < NRf+>, (@chanlist)
Sets the end level of the ramp
:TIMe < NRf+>, (@chanlist)
Sets the length of the end time
:RTIMe < NRf+>, (@chanlist)
Sets the rise time of the ramp
:STARt
[:LEVel] < NRf+>, (@chanlist)
Sets the initial level of the ramp
:TIMe < NRf+>, (@chanlist)
Sets the length of the start time or delay
:SINusoid
:AMPLitude < NRf+>, (@chanlist)
Sets the amplitude of the sine wave
:FREQuency < NRf+>, (@chanlist)
Sets the frequency of the sine wave
:OFFSet < NRf+>, (@chanlist)
Sets the DC offset of the sine wave