Agilent Technologies N6705

Appendix B SCPI Commands
190 Model N6705 User’s Guide
SCPI Command Description
[SOURce:]CURRent
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the output current
:TRIGgered [:AMPLitude] <NRf+>, (@chanlist)
Sets the triggered output current
:LIMit
[:POSitive]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the positive current limit (only on N678xA SMU, N6783A)
:COUPle <Bool>, (@chanlist)
Sets the current limit tracking state (only on N678xA SMU)
:NEGative
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the negative current limit (only on N678xA SMU, N6783A-BAT)
:MODE FIXed | STEP | LIST | ARB, (@chanlist)
Sets the current trigger mode
:PROTection
:DELay
[:TIME] <NRf+> (@chanlist)
Sets the over-current protection programming delay
:STARt SCHange | CCTRans, (@chanlist)
Sets the over-current protection programming mode
:STATe <Bool>, (@chanlist)
Enables/disables over-current protection on the selected output
:RANGe <NRf+>, (@chanlist)
Sets the output current range
:SLEW
[:IMMediate] <NRf+> | INFinity, (@chanlist)
Sets the output current slew rate (N678xA SMU)
MAXimum <Bool>, (@chanlist)
Enables/disables the maximum slew rate override (N678xA SMU)
[SOURce:]DIGital
:INPut
:DATA?
Reads the state of the digital port pins
:OUTPut
:DATA <NRf>
Sets the digital port
:PIN<1-7>
:FUNCtion <function>
Sets the selected pin’s function <function>= DIO, DINPut,
TOUTput, TINPput, FAULt, INHibit, ONCouple, OFFCouple
:POLarity POSitive | NEGative
Sets the selected pin’s polarity
:TOUTput
:BUS [:ENABle] <Bool>
Enables/disables BUS-generated triggers on digital pins
[SOURce:]EMULation <type>, (@chanlist)
Specifies the emulation mode on N678xA <type> = PS4Q, PS2Q,
PS1Q, BATTery, CHARger, CCLoad, CVLoad, VMETer, AMETer
[SOURce:]FUNCtion CURRent | VOLTage, (@chanlist)
Specifies current priority or voltage priority mode (N678xA SMU)
[SOURce:]LIST
:COUNt <NRf+> | INFinity, (@chanlist)
Sets the list repeat count
:CURRent
[:LEVel] <NRf> {,<NRf>}, (@chanlist)
Sets the current list
:POINts? (@chanlist)
Returns the number of current list points
:DWELl <NRf> {,<NRf>}, (@chanlist)
Sets the list of dwell times
:POINts? (@chanlist)
Returns the number of dwell list points
:STEP ONCE | AUTO, (@chanlist)
Specifies how the list responds to triggers
:TERMinate
:LAST <Bool>, (@chanlist)
Sets the list termination mode
:TOUTput
:BOSTep
[:DATA] <Bool> {,<Bool>}, (@chanlist)
Generate triggers at the Beginning Of STep
:POINts? (@chanlist)
Returns the number of BOST list points