Agilent Technologies TwisTorr 74 FS AG User Manual

Technical Information
Controller Installation
152/192 TwisTorr 74 FS AG On-board Controller User Manual / 87-901-054-01
1 Turn the pump upside-down;
2 Place the square plate bracket on the pump bottom;
3 Place the eight screws in the holes on the pump bottom;
4 Tighten the screws properly;
5 Turn the pump again;
6 Place the pump aligning the 4 holes of the square plate in the holes on the top of
the controller;
7 Place the four screws on the top of the controller;
8 Tighten the screws properly;
9 Plug the line cord and connect the pump cable to the pump;
10 Connect the mating connector with the jumper on the interlock signal to start the
pump.

Agilent Technologies TwisTorr 74 FS AG Specifications

General

Brand	Agilent Technologies
Model	TwisTorr 74 FS AG
Category	Controller
Language	English