Technical Information
J5 – Gauge Connector
17
TwisTorr 74 FS AG On-board Cont
roller User Manual / 87-901-054-01 159/192
J5 – Gauge Connector
This connector is used to connect to active gauges with its extension
cable (see orderable parts table). The pressure can be read via serial
line (WIN. 224) or by REMOTE I/O on Programmable Analog Out (in
this case, the controller replicates the signal coming from the gauge).
Figure 13 J5 Gauge Connector
+25VDC P MAX 2W
S
IGNAL
J
5
GAUGE
IDENTIFICATION
SIGNAL COMMON
COMMON
To Next Page
Loading...
