Technical Information
Controller Installation
154/192 TwisTorr 74 FS AG On-board Controller User Manual / 87-901-054-01
1 Turn the pump upside-down;
2 Place the L-shaped bracket (with external FAN)
on the pump bottom;
3 Place the square plate on the L-shaped bracket bottom;
4 Place the eight screws in the holes on the pump bottom;
5 Tighten the screws properly;
6 Turn the pump again;
7 Place the pump aligning the 4 holes of the square plate in the holes on the top of
the controller;
8 Place the four screws on the top of the controller;
9 Tighten the screws properly;
10 Plug the line cord and connect the pump cable
to the pump;
11 Connect the mating connector with the jumper
on the interlock signal to start the pump.
To Next Page
Loading...
