3
Table of Contents
Safety Information 1
Introduction 4
The Front Panel at a Glance 4
Getting Started
• To Inspect Package Contents 5
• To Charge a Battery 6
• To Power On the Handheld Scope 6
• To Reset to Factory Default Setting 6
• To Perform Self-Calibration 6
• To Set Time and Date 6
• To Set Auto Power Off 7
• To Select Language for Quick Help 7
• To Adjust Contrast of Display 7
• To Compensate Scope Probe 7
Scope Screen Display 8
Scope Connection Configuration 9
Meter Connection Configuration 10
Cursor Measurement 11
Save/Recall Setup and Waveform 12
Signal Triggering 12
Automatic Measurements 14
Data Logger 14
Quick Help 14
Charging the Battery 15
To Next Page
Loading...
