EasyManuals Logo

Agilent Technologies Varian 325-MS LC/MS User Manual

Agilent Technologies Varian 325-MS LC/MS
14 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
9300015500 Rev. C 14 of 14 Pre-installation Instructions
Varian will not accept liability for damage if obviously received damaged materials were
received without noting the damage on the receiving documents.
;
Check the checklist box: Shipping cartons inspected for damage. If there was
any damage, the conditions were reported.
Unpacking and Installing
The Varian Representative will review the Pre-installation Checklist with the customer to ensure
that the site requirements were met. The Varian Representative will unpack and install the
instrument and demonstrate the fundamental operation and maintenance procedures. The User
Representative must be present during the installation.
The Varian Representative will demonstrate that the system meets the performance
specifications, which are on the data sheet and any additional criteria explicitly written into the
sales contract.
Plan to analyze samples only after the installation is complete and the conditions of delivery
accepted. The process requires at least three days.
Spare Parts
Please refer to the 325-MS LC/MS Quadrupole Hardware Manual, part number 9300017200,
which has a list of spare parts for routine operation.
Preventive Maintenance
The customer is responsible for performing routine and preventive maintenance of the LC,
autosampler, MS, and data system. If using a nitrogen generator, perform the preventive
maintenance to ensure that the nitrogen supply is clean and dry. Any instrument problems
resulting from a contaminated gas supply are billable and not included in the Varian Warranty.
Perform regular preventive maintenance to increase the life of the system, to maximize system
uptime, and to optimize system performance. Please refer to the 325-MS LC/MS Quadrupole
Hardware Manual, part number 9300017200, for details. The Varian Representative will
describe and demonstrate these procedures during the installation.
Trademark Acknowledgment
Microsoft® and Windows® are registered trademarks of Microsoft Corporation. PEEK™ is a
registered trademark of the Victrex PLC Company, Lancashire, England. Other brand and
product names are trademarks or registered trademarks of their respective holders.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies Varian 325-MS LC/MS and is the answer not in the manual?

Agilent Technologies Varian 325-MS LC/MS Specifications

General IconGeneral
BrandAgilent Technologies
ModelVarian 325-MS LC/MS
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals