26
4.4 SWITCHING BETWEEN INTERCOM MODES
Your INSYDE unit can work in only one intercom mode at a time.
The current intercom mode is indicated by the color of the LED:
• When in DMC intercom mode, the LED flashes green at approximately 4-second intervals.
• When in Bluetooth
®
intercom mode, the LED flashes blue at approximately 4-second intervals
To switch from between intercom modes:
• On your unit, tap and .
x1
→ The color of the flashing LED changes and a voice message indicates the current
intercom mode.
5 TROUBLESHOOTING
5.1 SOFT RESET
If your INSYDE stops responding, reset it in one of these ways.
• Turning it off and then on again (see Getting Started).
• Using the supplied USB cable, connect your unit to the computer or wall charger for 30".
5.2 RESET PAIRING
This option deletes all paired units and devices.
To reset pairing:
1. Confirm your unit is in Standby Bluetooth
®
intercom mode (LED flashes blue slowly).
If your unit is not in Bluetooth
®
intercom mode, tap and .
x1
For more information, see Switching between Intercom modes.
To Next Page
Loading...
