Ahlborn ALMEMO 2290-4 V5 - Page 10

(2) FUNCTION KEYS
START/ M M/
▲
F1
CLEAR
▲
▼
F2
PROGR
▼ +/-
STOP
HOLD
PROGR, +/-, ▲ ▼, for entering programming values
▲
PROGR, CLEAR clear data, set meas. value to zero
PROGR, +/- calibrate measured value
START/
STOP cyclic measuring point scan
M
▲ select measuring point
M/
HOLD select measuring point, hold
F1 select measuring functions
max value (Hi) MH
min value (Lo) ML
free memory MF
#
print cycle PC *
average value AV
+
number of averaged values C
+
time constant s
+
volume flow V
+
time TM *
date DA *
start time ST
#
start date SD
#
end time ET
#
end date ED
#
F2 selecting programming functions
display mode DM
range R
averaging mode AM
+
cross-sectional area CS
+
diameter, normalized DN
+
atmospheric pressure mb ~
temperature compensation TC "
locking mode LM
limit value Max (Hi) LH
limit value Min (Lo) LL
Functions are activated by: zero point correction ZC "
All by switch-on with key PROGR slope (gain) correction SC "
Groups via display mode ambient temperature AT ^
Individually by interface command emissivity factor EF ^
Switch-on with key CLEAR base value BA
#
Option S Data Logger factor FA
* Interface module exponent EX
+
Flow sensors (Dim=m/s) analogue output start AS
^ Infrared sensors (IR-Flag) analogue output end AE
" pH probes (Dim=pH) baud rate, output format BR *
~
Humidity, dynam. pressure, O
2
sensors device address A*
10 ALMEMO

2290-4
Operating Controls