Aiphone IX-DVF - Page 124

124
Configuring the Station
■ Change contact
■ Unit error
■ Periodical Transmission
■ Initialization Notice
■ End Outgoing Call
■ Begin Incoming Call
■ End Incoming Call
Description A SIF command is sent when there has been a change in the contact input or relay output.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when a device failure is detected.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description Send device state periodically via SIF command. This will be sent at the interval set in “Periodical
Transmission Interval (→page 127)”.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when this device starts up.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when an outgoing call ends.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when an incoming call is received.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when an incoming call ends.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send