System settings (Settings (Table View))
143
1) Verify that the "Shared Group" table is shown.
If "Shared Group" is not visible, scroll the screen all the way to the left.
2) Enter the "Number" and "Group Name" of the group to be set up in the Group Registry.
Number: 01 through 99 (2 digits)
Group Name: 1-24 alphanumeric characters
3) Identify the group to be configured in "Group Registry List" section (01 through 50).
4) Identify the stations to be registered to the group in "Station List."
5) Click the cells that correspond to 3) and 4). As the pull-down menu appears, choose blank,
"U," or "M."
Blank: Station will not be registered in the group.
U: Station will be registered in the group. When the group is paged, audio is transmitted as
unicast.
M: Station will be registered in the group. When the group is paged, audio is transmitted as
multicast.
6) When done, click .
• When clicking , the data entered in the shared group will be registered to each
Master Station, and will be removed from the Shared Group section.
7) Click .
No group is registered in the default settings.
Register up to 50 groups for each Master Station.
When choosing "M," configure "2.4. Multicast Address (Master Station and Video Door
Station only)" ➤ P.122.
Group Name (furigana) is only accessible when using Japanese or Chinese language.
"Shared Group" registration should be completed prior to individual Master Station group
registration. If a "Shared Group" is configured using the same group number as a Master
Station individual group, the individual group setting will be overwritten.
To Next Page
Loading...
