Introduction
16
For Static IPv4 Address
Create new data
Use flowchart to create new configuration, e.g., when installing a new system.
Save the settings after configuring the system.
Refer to "Where the setting file is saved" ➤ P.82.
If the setting file is lost, station settings will need to be reconfigured.
1. Set "Language."
"3. Language" ➤ P.95
2. "New System."
"1.1. Create New System" ➤ P.81
3. Configure using "Settings (Table View)."
Configure the station according to the description of each item. "System settings (Settings (Table
View))" ➤ P.107
4. Install all stations.
Note the MAC addresses of all the stations.
5. Associate the created setting data to each station.
"4.2. Association Settings" ➤ P.97
Each station will be restarted, and "Number" and "IP Address" will be registered in each station.
6. Upload the setting data to all the stations.
"1.5. Upload Settings To Station" ➤ P.85
7. Set the clock of each station.
Refer to IX Master Station Operation Manual.
8. Set "LANGUAGE" of each Master Station.
Refer to IX Master Station Operation Manual.
9. Done.
To Next Page
Loading...
