System Settings (Settings (Station View))
217
Audio 1 RTP Start Port ♦
Audio 1 RTP End Port ♦
Audio 2 RTP Start Port ♦
Audio 2 RTP End Port ♦
2.6.1. Audio Buffer
Packets Buffered at Audio Start ♠
Maximum Packets Buffered ♠
Description Set the start port for the Audio 1 RTP communication range.
The (RTP End Port) should be greater than 210 digits from the (RTP Start Port). If a
smaller range is set, in some cases ports outside the range will still be used.
Settings 1-65534
Default values 20000
Description Set the end port for the Audio 1 RTP communication range.
The (RTP End Port) should be greater than 210 digits from the (RTP Start Port). If a
smaller range is set, in some cases ports outside the range will still be used.
Settings 1-65535
Default values 21000
Description Set the start port for the Audio 2 RTP communication range.
The (RTP End Port) should be greater than 10 digits from the (RTP Start Port). If a
smaller range is set, in some cases ports outside the range will still be used.
Settings 1-65534
Default values 22000
Description Set the end port for the Audio 2 RTP communication range.
The (RTP End Port) should be greater than 10 digits from the (RTP Start Port). If a
smaller range is set, in some cases ports outside the range will still be used.
Settings 1-65535
Default values 23000
Description Set the number of packets buffered until audio is started.
Settings 0-4
Default values 1
Description Set the maximum number of packets to be buffered.
When the system receives more packets, oldest packets are discarded.
Choose a figure greater than "Packets Buffered at Audio Start."
Settings 2-10
Default values 3
To Next Page
Loading...
