Exterior
2020 Flying Cloud 6-5
After hooking up the hose and turning on the city
water valve provided in the park, slowly open a faucet�
There will be a lot of spurts and sputtering until all
the air is expelled from the trailer system� If the water
heater is empty, it will take some time before all the air
is expelled and a steady ow of water occurs at the
faucet. Once a steady ow is achieved at one faucet
the others should be opened long enough to expel the
air in the lines going to them�
Your plumbing system has a built-in pressure regulator
to protect your lines and faucets from extremely high
pressures on some city water systems�
Shoreline Power Supply
The Power Cord hookup is located on the side of the
trailer� The cord may be stored in the rear exterior
compartment� The power cord is plugged into the trailer
receptacle and the City Power Service�
NOTE
Use only power cords recommended by Airstream.
Many campgrounds provide less than 30 amp service,
and your hookup may blow their fuse or circuit breaker�
If this happens, reduce the load and replace the fuse or
reset the breaker�
Remote Generator Hookup
A remote generator hookup, if equipped, will be located
on the front plate of the trailer behind the LPG tanks�
A generator can be plugged into the 120-volt system
using this feature� A minimum of 5�5 KW with a 30-amp
breaker will be required to sufciently power the 30-
amp service�
The system includes an automatic transfer switch to
prevent a power overload if a generator is started while
the trailer’s 120-volt shoreline is plugged into a 30-amp
service� The transfer switch will automatically switch
power from a shoreline source to a generator when it
senses power entering the switch from the generator�
When power is cut from the generator, the switch
returns to the shoreline as its power source�
NOTE
The remote generator hookup is not available with
50 amp service.
TV/Satellite Inlets and Receptacle Outlets
An exterior inlet for TV/Satellite and an outlet for a 120
volt receptacle is located on the side of the trailer and
are labeled for your convenience�
Hitch/Coupler
The EZ-Latch coupler features a simple-to-use latching
mechanism� Hooking up is as easy as dropping the
coupler on to your hitch ball� Simply make sure that the
coupler is properly lined up with the ball, then lower
the coupler� The coupler will automatically open and
latch into place when lowered onto the hitch ball� To
disengage coupler, pull up on latch and raise coupler
off of hitch ball� Return the coupler latch to the latched
position to ensure that coupler is ready to be latched
again�
The coupler features a strong composite handle, If the
handle does get damaged or becomes missing, the
coupler is still completely operational until the handle
can be replaced� Replacement parts can be purchased
through your Airstream Dealer� See additional
information included in your owner’s packet�
WARNING
Always make sure coupler is properly attached and
latched before towing.
To Next Page
Loading...
