AirTouch 2 - 5.3 Grouping Zones

20
For ease of control operation, multiple zones can be grouped together.
The grouped zones are treated as one group with its own name and turned on
or o together. Individual balanced damper position is not aected by grouping,
which means zone balancing can be conducted before or after grouping.
Grouping can be carried out as follows:
a) In ‘Installers’ screen, touch Grouping to enter ‘Grouping’ screen.
5.3 Grouping Zones
b) Then touch + or - button to add or minus zones to the group
c) Repeat steps b) and c) to dene all groups
d) Press the Reset button if the grouping is corrupted.
e) Touch the zones button will show all zone assignments and you can
choose the zones for a group.
Grouping Zones
Note: If a zone is marked as Disabled, it cannot be used in a group,
a good and available zone can be chosen instead.