Operating Modes
Pick Mode
Specifies the ability of the reader to decode labels only
when they are close to the center of the aiming pattern,
which is the area indicated by the two blue arrows. Pick
Mode is a Decoding and Transmission process where bar
codes that are not within the configurable distance from the
center of the aiming pattern are not acknowledged or
transmitted to the host. It is active only while the scanner is
in Trigger Single mode. If the scanner switches to a different
Read Mode, Pick Mode is automatically disabled.
NOTE
This feature is not compatible with Multiple
Labels Reading in a Volume. See the PRG
for more information.
PICK MODE
ENTER/EXIT PROGRAMMING MODE
♦
PIck Mode
=
Disable
Pick Mode
=
Enable
To Next Page
