Airzone FLEXA 3.0 IBPRO6 Quick Installation Guide

18
ES
EN
FR
IT
PT
DE
ASSEMBLY AND CONNECTION
Important: Respect the color code for all the system elements.
1.- Connecting the control elements of the system (AZCE6BLUEFACEC, AZCE6THINKC, AZCE6LITEC, etc.)
Connect the control elements of the system in one of the 3
expansion bus terminals . Use (2x0.5+2x0.22 mm
2
) Airzone
wire. The connection can be both a Bus connection or a star
connection. For elements externally powered at 110/230 Vac,
for their communications, it is only necessary to connect the
poles "A" and "B" of the bus. (E.g. AZCE6OUTPUT8). For added
security, secure the wires using the turrets.
In case of wireless element, check it has the battery on.
2.- Connecting the motorized elements
Connect each output to the actuator of its
corresponding control zone. Identify the actuator
outputs to facilitate the maintenance. Do not
connect more than two actuators per output. Use the
Airzone cable (2x0.75 mm
2
) for the connection. Highest
recommended length: 20 m.
Nº
Description
Expansion bus
Wireless module
SW1
Automation bus
AC unit bus
Actuator outputs
Alarm input (normally closed)
Temperature probe
CMV/Boiler
AC Start-stop relay
Power
On/off module (Only
AZCE6IBPRO6)

Airzone FLEXA 3.0 IBPRO6 Specifications

General

Brand	Airzone
Model	FLEXA 3.0 IBPRO6
Category	Thermostat
Language	English