Airzone FLEXA 3.0 IBPRO6 Quick Installation Guide

20
ES
EN
FR
IT
PT
DE
System reset
If you want to return to factory values, press and hold SW1 until LED D19 stops blinking. Wait for the
LEDS to go back to their normal state before starting with the initial configuration process.
Zone reset
If needed, to reset a zone follow the steps shown in the section Advanced Settings, Zone Parameters for
Blueface and Think thermostats and the section Lite thermostat Reset if using Lite thermostats.
Changing batteries
To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
Important: We recommend using of top-brand batteries. Using low-quality
batteries may reduce the duration of use.
Remember to deposit the old battery into an appropriate recycling point.
Note: Do not forget to remove the security system before taking away the
thermostat from the wall.
ASSEMBLY AND CONNECTION EVALUATION
Check the following aspects:
- The state of the LEDs of the main control board and the rest of control elements. Check the self-diagnose section of
the data sheet of the elements.
- The main control board LEDs of opening dampers light up sequentially.
- If all the thermostats are powered.
Important: In the main control board, check the correct performance of D3, D11 and D19 LEDs and motorized elements.
Meaning
D3
Main control board
activity
Blinking Green
D11
Main control board
power
Solid Red
D19
Association channel:
active
Solid Red
Open dampers
Solid
Green
Close dampers
Solid
Red

Airzone FLEXA 3.0 IBPRO6 Specifications

General

Brand	Airzone
Model	FLEXA 3.0 IBPRO6
Category	Thermostat
Language	English