68
APPENDIX 3: MAIN CONTROLLER AND ZONE THERMOSTAT
RESET
In some cases it is necessary to reset the main controller or the zone thermostats. To
do so, follow procedure:
1.- Main Controller Reset: With the main controller power supplied, press hold on the
switch labeled as “Radio” (label 18 on Fig. 2) for 12 seconds until LEDs D1 and D2 light
both at the same time. Once this is done, start again the association process with each
thermostat
2.- Tacto Flexa Reset: With the thermostat set to Off, press and hold on the Automatic
Mode icon (label 13 on Fig. 6) until the indication “RST” appears on the screen. Press on
Airzone icon for the selection arrows to appears. Select “Si” and confirm with a press on
the Airzone icon. You will see “PULSE” on the screen.
To Next Page
Loading...
