10
A-MIP 210 V1.06
Use
Night mode operation
• The aivia is equipped with a light sensor.
When luminosity becomes insufficient, white indicators
blink to signal the Aivia site.
• Open the Aivia door by pulling it.
Visual alert is given by the blinking ot the red indicators.
• Take the AED Off.
• Get to the victim.
• Power on the AED.
• Follow the AED’s instructions.
Heating option operation
• The heating option allows to maintain the AED
operating temperature within some limits. In extreme
cold temperatures, it is appropriate to check that the
alert temperature is not signaled by blinkings of the red
indicators.
• The fan allows the heat to be drawed out of the Aivia.
In hot weather, it is appropriate to check that the alert
temperature is not signaled by blinkings of the red
indicators
Using the Aivia
If you witness an incident needing an AED.
• Contact emergency services.
Speak using a clear and loud voice, describe the
situation without forgetting to precise the incident
location. The user code will allow you to unlock the aivia.
Aivia maintenance
• Wash the Aivia surfaces using a wet cloth. Wipe the
Aivia with a clean & dry cloth. Do not use washing or
chemical products, they could damage it.
• Do not rub the Aivia with any hard object, you might
damage it permanently or streak it.
• Do not use a high pressure cleaner.
Alert operation
Door opening alert:
• When the door is opened the visual alert is given
by the blinking of the red indicators.
• If your Aivia is equipped with the siren option
(Reference : X2A210-XX100 or X2A210-XX101)
It will be activated during 3 minutes .
Temperature alerts:
• The temperature alert, signaled by 4 repeated
blinkings of the red indicators door close is triggered
when the temperature gets below the minimum
temperature defined, or over the maximum
temperature defined.
After using the defibrillator
• Do not place the defibrillator back inside the AIVIA be-
fore reactivating it.
• Follow the instructions in the defibrillator’s manual to
reset it for use.
• The manufacturer may be able to help reactivate the
defibrillator. Please feel free to contact them.
• After reactivating the defibrillator, replace it inside the
AIVIA using the instructions in the section "Setting up the
defibrillator."
• Replace the seal using the instructions in the section
"Installing a seal".
• Type the user code to unlock the Aivia.
To Next Page
Loading...