AJA HD10MD4 - Installation

HD10MD4 Mini-Converter v1.1 www.aja.com
7
Installation
Typically, installation consists of the following:
Direct Control 1. Disconnect DC power from the converter.
2. Configure the DIP switches for the desired equipment configuration and video
formats.
3. Connect video equipment to the converter BNCs.
4. Apply power to the converter.
Mini-Config Control 1. Disconnect DC power from the converter.
2. Connect video equipment to the converter BNCs.
3. Apply power to the converter.
4. The converter will now run using the default factory settings. If you wish to alter the
factory settings with Min-Config you’ll need to:
• Set DIP switch 1 ON (right) to permit remote Mini-Config control.
• Install the AJA Mini-Config software on your computer.
• Attach the unit via USB to your computer.
• Make your changes using the Mini-Config setup screens. This process is detailed in
"Chapter 2: Operation on page 8".