For detection and pairing to occur, the detector should be located within the
coverage area of the wireless network of the hub (at a single protected object). The
connection request is transmitted for a short time: at the moment of switching on
the device.
If the device failed to pair (LED blinks once per second), switch it off for 5 seconds
and retry. The detector connected to the hub appears in the list of devices in the
app. The update of the detector statuses in the list depends on the device ping
interval set in the hub settings (the default value is 36 seconds).
States
3. Tap Add — the countdown will start.
4. Switch on the device.
1. Devices
2. DoorProtect Plus
To Next Page
Loading...
Need help?
General
