ENGINE
OIL RECOMMENDATION
Use a premium quality 4-stroke motor
oil to ensure longer service life of your
motorcycle. Use only oils that meet or
surpass quality requirements of API
classes SF or SG:
SAE 10W/40 or 15W/40 API SF or SG
Oil level
Engine oil level can be checked in the
glass in front of rear brake pedal. Oil
level should be between the two lines in
the glass. If oil level is below the lower
line, refill immediately. If your engine is
losing oil, contact an AJP dealer
immediately.
! WARNING !
Insufficient oil or poor quality oil
results in premature wear of the
engine and may cause severe
damages!
BREAK-IN (RUNNING-IN)
The following explains why is so
important proper break-in to achieve
maximum life and performance from
your new AJP.
Even very precisely machined sections
of engine components have rougher
surfaces than components that have
been sliding across one another for
quite some time; therefore, every
engine needs to be broken in during the
first 1,000Kms.
For this reason, do not load engine
more than 50% of its capacity during
the first 500 kilometres, avoiding full-
throttle. In the following 500 kilometres,
you may load the engine up to 75% of
its capacity, using the gearbox
frequently.
Allow sufficient idling time, about 1-2
minutes, after warm or cold engine start
up before applying load or revving the
engine. This allows time for the
lubricating oil to reach all critical engine
components.
Observe your first and most critical
service. The 1000 Kms service is the
most important service your AJP will
receive. All adjustments will be
restored, all fasteners and spokes will
be tightened and dirty oil and oil filter
will be replaced.
Máx
Min
! WARNING !
Incorrect break-in may cause severe
damage to your motorcycle or
significantly reduce your motorcycle
lifetime!
INSPECTIONS BEFORE
RIDING
Check the following before each
start
When you start off, the motorcycle must
be in perfect mechanical condition. For
safety reasons, you should make a
habit of performing an overall check
before each start.
The following checks should be
performed:
1 – Oil level. Insufficient oil results in
premature wear in engine components
and damages in engine itself.
2 - Fuel. Check there is sufficient fuel in
the tank;
PR4 User’s manual Page
9
To Next Page
Loading...
