Akai AM-U61

CONNECTIONS
ATTENTION
' * Turn off ali the equipment before connecting.
i * A and B SPEAKER terminals accommodate speakers of 4
to 16 ohm impedance, but if both A and B SPEAKER ter-
minals are used simultaneously, speakers of 8 to 16 ohm
impedance must be used.
Connect so that the live part of the speaker wire cannot be
touched.
A System
B System
Right
Left
Tape Deck (TAPE 1)
Connect to Ground =
terminals of turn-
tables, tape decks,
etc.
aie SHOCK MAZARD 00 HOT OFLA *
ArBiR 18: | RISQUE OF CHOC ME PAS ENLEVER ¢
SEAUHRUNSSGESARN MICHT OFFER”
UNSWITCHED —— gwitcHeD
AU OUTLETS.
\ Ground
i Wire
=)
To Household
RIGHT LINE IN
.y
RIGHT LINE OUT
>
LEFT OUTPUT
|
|
|
|
|
|
|
|
|
|
] LEFT LINE IN
| LEFT LINE OUT yy AC Outlet
yy
|
|
|
I
|
I
|
|
D Tape Deck or
HT OUTPUT p
RIG UTPU + Crystal or
Ceramic Type
L Cartridge
Turntable
Magnetic
Type
or
Tape
Deck
(TAPE
2)
Moving
coil
Type
'
Cartridge
Turntable
HOW TO CONNECT SPEAKERS
’
1.
Strip
over
1
cm
length
of
vinyl
covering
from
the
LOOSEN
TIGHTEN
end
of
the
speaker
wire.
Loosen the terminal and wind the wire around the
terminal.
Tighten the terminal.
Pull the wire to make sure that the wire is secure.
Be sure to match the plus and minus and left and
right. If the plus and minus terminals are reversed,
poor and unnatura! sound will result.
+PO ON