Akai AP-Q310

Vil. MECHANICAL ADJUSTMENT
REAR
af
ANGLE (A)
BRAKE LEVER
(b)(c)(d)
ELEVATION
LEVER(B)
ELEVATION LEVER (C)
CUEING LEVER
u)
FRONT
Fig. 6 Tone Arm Lifter Adjustment and Tone Arm Brake Adjustment
1. TONE ARM LIFTER ADJUSTMENT
(Refer to Fig. 6)
1) The height of the stylus point is adjusted when the
arm is lifted in AUTO PLAY and manually (cueing
lever).
will be about | - 2 mm higher than when the stylus
is lifted in AUTO PLAY. (Check by moving the
cueing lever W (UP)... W (DOWN).
a) Adjust the size selector to 17 cm.
b) Remove the rubber mat and platter and turn the
main gear 3/4 counterclockwise. (Lead in = arm
down > arm up = when returning)
c) Loosen the screws (b) and (c).
d) Check that the screw (a) is fully clockwise.
e) Set the cueing leverto W (UP).
f) Tighten the screw (b) slowly so that the stylus point
g) Tighten the screw (c) until the end almost touches
the elevation lever (c). (Cueing lever: VW )
h) While repeating the operation of W (UP) = W
(DOWN) of the cueing, tighten the screw (c) until
the stylus point hardly changes.
i) Have the auto return finished by turning the main
gear 1/4.
j) Paintlock the screws (a), (b) and (c).
ns
11