Akai AP-Q310 - Lead-In;Lead-Out Adjustment 0.0; 4, Return Plunger Position Adjustment

3. LEAD-IN/LEAD-OUT ADJUSTMENTS
(Refer to Fig. 7)
1) Lead-in position 2) Lead-out position
a) Place a record on the Platter. a) Auto-play the record and confirm where auto-
b) Auto-play the record and confirm where the Stylus return begins.
descends. ~ b) Turn the Lead-out Adjustment Screw with a screw-
c) Depress the CUT/RETURN switch to return the driver:
Tone Arm to the Tone Arm Rest. * The Lead-out Adjustment Screw is visible with-
d) Move the Tone Arm towards the Platter until the out moving the Tone Arm.
Lead-in Adjustment Screw is visible. Clockwise: To delay auto-return.
e) Turn the Lead-in Adjustment Screw with a screw- Counterclockwise: To hasten auto-return.
driver: NOTE: Carry out both adjustments little at a time and
Clockwise: To make the Stylus descend towards confirm the position after each adjustment.
the Spindle.
Counterclockwise: To make the Stylus descend
away from the Spindle.
4. RETURN PLUNGER POSITION ADJUSTMENT (Refer to Fig. 8)
MAIN GEAR
ue
Fig. 8 Return Plunger Position Adjustment
Press the reject lever down with a finger until the reject
plate touches the main gear pin. Operate the plunger
(SL901) in this position and adjust the installation screw
at exactly the point where the gap A between the reject
lever and plunger disappears. (Refer to Fig. 8)
After adjustment, confirm that the Auto Play is operat-
ing.
13