Akai AP-Q310

No.
MODEL AP-Q310/C
VOLTAGE AND CYCLE CONVERSION
REAR
FUSE PCB
110 tp 1200 AREA: S0OmA
220
He
240V
AREA’
SOOmMA
Fig. 1 Voltage Conversion (U Model only)
VOLTAGE CONVERSION
Models for Japan, Canada, USA, Europe, UK and Australia are not equipped
with this facility.
Each unit is preset at the factory depending on its destination, but some
units can be converted to 110-120V or to 220-240V as required.
If voltage change is necessary, this can be accomplished as follows:
1) Disconnect the power cord.
2) Remove the bottom cover.
3) Remove the existing Line Voltage Fuse and insert the required Line
Voltage Fuse in the proper fuse holder according, to the printed
instructions.
CYCLE CONVERSION
With DC servo motor, cycle conversion is not necessary.