Akai AP-Q310 - Page 34

MODEL ap-9310/C
IV. MECHANICAL ADJUSTMENT
REAR
ANGLE (A) (
BRAKE LEVER
A“
7
>
L7ex=——- ARM LIFTER
ELEVATION LEVER CA)
ELEVATION
LEVER (B) 64)
ELEVATION LEVER CO)
CUEING LEVER Fig. 6
1. TONE ARM LIFTER ADJUSTMENT (Fig. 6)
1)
The
height
of
the
stylus
point
is
adjusted
when
the
arm
is
lifted
in
AUTO PLAY and manually (cueing lever).
a) Adjust the size selector to 17 cm.
b)
c)
dq)
e)
£)
Remove the rubber mat and platter. and turn the main gear 3/4
counterclockwise. (Lead in-~arm down-—>» arm up —> when returning)
Loosen the screws (b) and (c).
Check that the spring of screw (a) is fully tightened.
Set the cueing lever oo & (UP).
Tighten the screw (b) slowly so that the stylus point will be
about 1-2 mm higher than when the stylus is lifted in AUTO PLAY.
(Check by moving the cueing lever Vv (UP) ... V (own) :
Tighten the screw (c). until the end almost touches the elevation
lever (c). (Cueing degees VS