101
Chorus
Use this tab to apply and adjust the settings for the built-in Chorus effect.
Parameter Description
alue Range
Rate Modulation speed of the effect. 0.01 – 10.0 Hz
Delay Length of time the wet signal is offset from the dry signal. 0.00 – 24.00 ms
oices Number of voices used in the chorus effect. 3, 4, 6
LFO Wave Waveshape of the low-frequency oscillator for the chorus effect. Tri, Sine
Depth
mount of pitch modulation of the effect. 0.00 – 24.00 ms
Width Stereo width of the chorus effect. Higher values give wider stereo
separation.
0–100%
Lo Cut Center frequency for the chorus low-cut filter. 20.0 Hz – 1.0 kHz
Mix Wet/dry amount of the chorus effect. 0–100%
Delay
Use this tab to apply and adjust the settings for the built-in delay effect.
Parameter Description
alue Range
Time Length of time between the dry signal and the delayed signal.
When Sync is set to Free:
1 ms – 2.00 s
When Sync is set to Sync:
1/32 – 8/4
Sync
Enable to sync the Delay Time to the Global Tempo, disable to set the
Time in milliseconds.
Off, On
Feedback
mount of delay signal fed back into the delay line. 0–100%
Mix Wet/dry amount of the delay effect. 0–100%
Damp Center frequency of where the delayed signal will be dampened. 1.00 – 20.0 kHz
Reso
mount of resonance of the feedback signal. 0–100%
Reso Freq Center frequency for feedback resonance. 100 Hz – 10.0 kHz
Ratio
Reduces the delay Time in either the Le
t or Right stereo field. This is
useful for creating offset, panned delays.
L 100:50, R 50:100
HPF Center frequency for delay signal high-pass filter. 20.0 Hz – 1.0 kHz
Width Stereo width of delay signal. Higher values give wider stereo separation. 0–100%
To Next Page
Loading...
