EasyManua.ls Logo

Akai FORCE

Akai FORCE
259 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
100
Setup
Use this tab to adjust plugin setup parameters.
Parameter Description
V
alue Range
Controller Destinations
V
elocity 1 Send Velocity data to one of the following control
destinations.
A
mp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
Depth
A
mount of modulation applied. 0–100%
V
elocity 2 Send Velocity data to one of the following control
destinations.
A
mp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
Depth
A
mount of modulation applied. 0–100%
Modwheel Send Modwheel data to one of the following control
destinations.
A
mp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
Depth
A
mount of modulation applied. -100 – 0 – 100%
A
ftertouch Send Aftertouch data to one of the following control
destinations.
LFO 1 Depth, Cutoff,
Osc1 Shape, Osc2
Shape, Osc1&2 Shape
Depth
A
mount of modulation applied. -100 – 0 – 100%
Setup Polyphony Number of allowable voices, and how voices are
triggered.
Legato, Retrigger, 2, 3, 4
Bend Range Number of semitones up or down controlled by MIDI
pitch bend messages
2–12 (semitones)
Glide Time
A
mount of time to slide from the pitch of one note to
the next note played.
1.00 ms – 100 s
Glide All Enables or disables pitch gliding for all triggered
notes, not just legato notes.
Off, On
Detune
A
mount of detuning applied. This setting is only
applied when Doubling is enabled.
0–100%
Doubling Enables or disables voice doubling. Off, On
Output Shape
A
mount of signal sent to a Tube Drive. 0–100%
Width Stereo width of the audio signal. Higher values give
wider stereo separation.
0–100%
Level Overall output volume of the plugin. -inf dB – +12.0 dB

Table of Contents

Other manuals for Akai FORCE

Related product manuals