Akai FORCE

88
Bell / Noise
Use this tab to apply and adjust the settings for the Bell and Noise sounds.
Parameter Description
V
alue Range
Bell Tune Pitch of the bell sound, in semitones above the root
pitch.
0– 60 semitones
Dry/PU Mix of Dry versus Pickup signal for the bell sound. -100% – 0%
–
+100%
V
olume Level of the bell sound. -inf dB – +6.0 dB
Tune Keytrack Ties the tuning of the bell sound to the pitches played. 0–100%
Decay How long it takes for the bell sound to dissipate 100 ms – 7.0 s
Keytrack Ties the amount of bell sound to the pitch being
played.
At negative values, the bell sound is increased as the
pitch increases.
At positive values, the bell sound is increased as the
pitch decreases.
-100% – 0%
–
+100%
Noise Freq Center frequency of the noise effect 200 Hz – 16.0 kHz
Random
A
mount of randomization applied to the noise effect 0–100%
Mix Level of noise effect present -inf dB – +6.0 dB
A
ttack Length of time for the noise effect to reach full level 1–50 ms
Decay Length of time for the noise effect to dissipate 100 ms – 3.00 s
Keytrack
Ties the Freq to the pitch being played.
0–100%
Setup
Use this tab to adjust general settings for the plugin.
Parameter Description
V
alue Range
Polyphony Number of voices available. 1–16 Voices
Master Volume Overall level of the plugin. -inf dB – +6.0 dB
V
elo Level
A
djusts how much incoming velocity is applied. 0–100%
V
elo Tone Ties the incoming velocity to tone.
At higher values, increased velocity increases tone brightness.
0–100%
V
elo Attack Ties the incoming velocity to the attack envelope.
At higher values, low velocities feature longer attack times.
0–100%