Akai FORCE

89
Trem / Tube / Chorus
Use this tab to apply and adjust the settings for the built-in Tremolo, Tube (Over Drive), and Chorus effects.
Parameter Description
V
alue Range
Tremolo Rate Modulation speed of the effect.
When Sync is set to Free:
0.25 – 13.00 Hz
When Sync is set to Sync:
8
/
4 – 1/16
Sync
Sync the Tremolo Rate to the Global Tempo or let it
run Free.
Free, Sync
Mode
Select Pan for stereo field modulation, or Tremolo for
amplitude modulation.
Pan, Tremolo
Depth
A
mount of modulation applied. 0–100%
Tube Drive
A
mount of drive applied. 0–100%
Headroom
A
mount of gain reduction between the clean signal
and the driven signal.
-30.0 – 0.0 dB
Saturation
A
mount of saturation applied. 0–100%
Output Output level of the tube driven signal. -20.0 – 0.0
–
+20.0 dB
Chorus Rate Modulation speed of the effect. 0.40 – 3.20 Hz
Depth
A
mount of pitch modulation of the effect. 0–100%
Mix Wet/dry amount of the chorus effect. 0–100%
Delay
Use this tab to apply and adjust the settings for the built-in Delay effect.
Parameter Description
V
alue Range
Time
A
mount of time between the dry signal and the delayed signal.
When Sync is set to Free:
1 ms – 2.00 s
When Sync is set to Sync:
1/32 – 8/4
Sync
Sync the Delay Time to the Global Tempo or set to Free to adjust Time
by milliseconds.
Free, Sync
Mix Wet/dry amount of the delay effect. 0–100%
Feedback
A
mount of signal fed back into the delay line. 0–100%
Damp Center frequency of where the delay signal will be dampened. 1.00 – 20.0 kHz
Reso
A
mount of resonance of the feedback signal. 0–100%
Reso Freq Center frequency for feedback resonance. 100 Hz – 10.0 kHz
Ratio
Reduces the delay Time in either the Left or Right stereo field. This is
useful for creating offset, panned delays.
L 50:100, R 50:100
HPF Center frequency for delay signal high-pass filter. 20.0 Hz – 1.0 kHz
Width Stereo width of delay signal. Higher values give wider stereo separation. 0–100%