90
Spring Reverb
Use this tab to apply and adjust the settings for the built-in Spring Reverb effect.
Parameter Description
alue Range
Pre-Delay Length of time between dry signal and reverberated signal. 0 ms – 250 ms
Time Length of reverb tail. 1.0 – 10.0 s
Mix Wet/dry amount of the reverb effect. 0–100%
Diffusion Rate of increasing density of reverb reflections.
At lower settings, the sound of individual reflections is more present.
At higher settings, reflections are more uniform.
0–100%
Width Stereo width of reverb signal. Higher values give wider stereo separation. 0–100%
Low Cut Center frequency for reverb signal low-cut filter. 20.0 Hz – 1.00 kHz
To Next Page
Loading...
