93
Effects 1
Use this tab to adjust the settings for the Low-Frequency Oscillator and Modulation, Distortion and Hype effects.
Parameter Description
alue Range
LFO Rate Speed of the low frequency oscillator.
When Sync is set to 1st Note or Each Note:
0.03 – 30.00 Hz
When Sync is set to Temp+Note or Tempo+Beat:
8/4 – 1/64
Sync Enables or disables LFO sync, and sets how it is
synced when enabled.
Off, 1st Note, Each Note,
Tempo+Note,
Tempo+Beat
Depth
mount of LFO modulation applied. 0–100%
Mod Rate Speed of modulation. 0.05 – 20.00 Hz
djust Length of time the wet signal is offset from the dry
signal.
0.0 – 24.0 ms
Depth
mount of modulation applied. 0–100%
Mix Wet/dry mix of the modulation effect. 0–100%
Distortion Drive
mount of drive applied. 0–100%
Bias Emulates amount of voltage sent to a tube powe
-amp. -100 – 0 – 100%
Output Output level of the distorted signal. 0–100%
Mix Wet/dry mix of the distortion effect. 0–100%
Hype Low Dampens or maximizes low end frequencies. -12.0 – +12.0 dB
Lo-Mid Dampens or maximizes low-mid frequencies. -20.0 – +20.0 dB
Hi-Mid Dampens or maximizes high-mid frequencies. -20.0 – +20.0 dB
High Dampens or maximizes high end frequencies. -12.0 – +12.0 dB
To Next Page
Loading...
